Art TCS Betriebsanleitung PDF herunterladen (Seite 6)

ART TCS Twin Compressor System

CONTROLS & INDICATORS

1Power – Switches the unit’s power on and off.

2Instrument Input and Level – The front ¼” jack is intended for

instrument level signals and the level control applies from 0 to 30db of

gain to the signal.

When using the front instrument jack, the rear inputs on Channel 1 are

disconnected.

3Compression Controls (Attack, Release, Threshold, Ratio) –

These four controls control the amount of compression and its’

transient settings. These are continuously active throughout all V3

settings (V3 optimizes ranges for selected application).

4Noise Reduction Controls (NR Thresh, Shelf, NR Active LED) –

These two controls set the noise reduction characteristics. They are

continuously active throughout all V3 settings. Users can look at the

LED to determine if the current NR is an expander or a gate by viewing

it’s dimming characteristics. When the LED simply turns on and off the

NR is a gate, when it slowly fades in and out it is an expander.

As the NR Thresh is increased, the noise reduction will become more

sensitive to the signals. Thus, more of the signal will be affected by the

NR.

The Shelf control tunes the Noise Reduction detection circuitry such

that it is less sensitive to certain frequencies. When fully counter-

clockwise the noise reduction is most sensitive to lower frequencies,

and when fully clockwise the noise reduction is most sensitive to higher

frequencies.

- 7 -

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Keine Kommentare

Art TCS Betriebsanleitung Seite 6