The ART SLA-2 Studio Linear Amplifier TABLE OF CONTENTS Safety Precautions ...
10 XLR INPUT JACKS The XLR Input jacks are Pin Two positive, Pin Three negative, and Pin One is ground. This connection is for balanced connections
11 Spade Connector – Loosen the red and black caps on the binding posts (don’t completely remove). Insert the spade connector into the binding post a
12 GROUND LIFT SWITCH This switch is used to disconnect the internal ground signal from the chassis (case) ground. This may be used to reduce 50/60H
13 MONO BRIDGE OPERATION Be sure the amp is shut off. Press the Stereo/Mono switch (on the back) to the “in” position. Connect an input signal to
- 14 - WARRANTY INFORMATION Limited Warranty Applied Research and Technology will provide warranty and service for this unit in accordance with the
- 15 - SERVICE The following information is provided in the unlikely event that your unit requires service. 1) Be sure that the unit is the cause o
- 16 - SLA-2 SPECIFICATIONS Dimensions 1.75”H x 19.0” W x 13.5”D Weight 19.8 lbs., 9.0kg. Input Connections XLR,EUROBLOCK (balanced),
2 IMPORTANT SAFETY INSTRUCTION – READ FIRST This symbol, whenever it appears, This symbol, wherever it appears, alerts alerts you to t
3 SAFETY PRECAUTIONS Warning: For optimum performance and reliability, do not operate the amplifier with a speaker load of less than 4 Ohms per ch
4 INTRODUCTION Thank you for purchasing an ART SLA-2 Studio Linear Amplifier - and congratulations, you now own one of the most versatile amplifiers
5 INSTALLATION The SLA-2 may be used in a wide variety of project and professional studio environments. Self-contained in a steel and aluminum enclo
6 SECURITY COVER For commercial installations it may be desirable to set the gain controls on the power amp,
7 CONTROLS & INDICATORS – FRONT PANEL FRONT PANEL DIAGRAM POWER SWITCH The Power Switch is located on the front of the unit, directly in
8 PROTECT INDICATOR LED The LED will glow when the channel goes into protect mode. In protect mode, the output signal to the speakers will be mute
9 REAR PANEL CONNECTIONS REAR PANEL DIAGRAM It is easy to interface the SLA-2 with a wide variety of equipment. All inp
Kommentare zu diesen Handbüchern